Drain Tube
A
B
C
D
A. ⁷⁄₈" adjustable hose clamp
C. ⁷⁄₈" adjustable hose clamp
B. Drain tube (ice bin to drain pump)
D. Drain pump reservoir inlet
5. Install vent tube ( ⁵⁄₁₆ " ID x 32" [81 cm]) to drain pump
reservoir vent. Use one ⁵⁄₈ " small adjustable clamp, supplied.
See “Parts Locations” illustration.
NOTE: Do not install household drain tube at this time.
Parts Locations
A
B
C
D
E
G
F
A. Vent tube
E. Ice maker unit power cord
B. ⁵⁄₈" hose clamp
F. #8-32 x ³⁄₈" pump mounting screws
C. Drain pump discharge tube
G. Drain pump power cord, clamp
and screw
D. Drain pump
6. Remove power cord clamp and ground screw attached to
ice maker power cord, which is mounted to the unit base.
See “Parts Locations” illustration.
NOTE: Clamp and screw will be reused.
7. Slide drain pump into the ice maker base on the right side.
The pump mounting tab should slip into the rectangular slot
in the ice maker base. It will be necessary to tip the pump
slightly to slip into the slot. See “Drain Pump Mounting Tab
Slot” illustration.
Page 8