Electrolux EWF12832 User Manual page 29

Malfunction Possible cause
There is water
on the floor:
Unsatisfactory
washing
results:
The door will
not open:
The machine
vibrates or is
noisy:
Cycle time
longer than
displayed:
Too much detergent or
unsuitable detergent (creates too
much foam) has been used.
Check whether there are any
leaks from one of the inlet hose
fittings. It is not always easy to
see this as the water runs down
the hose; check to see if it is
damp.
The drain hose is damaged.
Too little detergent or unsuitable
detergent has been used.
Stubborn stains have not been
treated prior to washing.
The correct temperature was not
selected.
Excessive laundry load.
The program is still running.
The door lock has not been
released.
There is water in the drum.
The transit bolts and packing
have not been removed.
The support feet have not
been adjusted.
The laundry is not evenly
distributed in the drum.
There is very little laundry in the
drum.
Unstable floors eg. wooden
floors.
Detergent over dose.
Machine unbalance.
ENGLISH
Solution
Reduce the detergent
quantity or use another one.
Check the water inlet hose
connection.
Change it with a new one.
Increase the detergent
quantity or use another one.
Use commercial products
to treat the stubborn stains.
Check if you have selected
the correct temperature.
Reduce load.
Wait until the end of
washing cycle.
Wait about 5 minutes.
Select 'Spin' program to
empty out the water.
Check the correct
installation of the appliance.
Check the correct levelling
of the appliance.
Pause the machine and
redistribute laundry manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
Redistribute laundry manually
in the drum and start the spin
phase again. Refer to relevant
paragraph in "Positioning"
section.
29