Table of Contents
Advertisement
INSTALL USING LATCH
4
Locate the LATCH anchor bars in your vehicle. Attach both LATCH
Connectors to the vehicle LATCH anchor bars.
Pull up on the end of the LATCH Adjuster strap (Pull 1 st ) until
5
strap is tight.
6
Pull on the
Child Restraint.
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Child Restraint should not move more than 1" (25 mm) from
vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant's head
does not fall forward. If necessary, loosen the Latch Strap, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
44
™
SuperCinch
LATCH
Tightener strap (Pull 2 nd ) to secure the
Hide quick links:
Advertisement
Table of Contents
