Sanyo KS1872 Technical & Service Manual page 74

How to Use the Remote
Control Unit
Remote Control Unit
Installation Position
DO NOT
Mounting the Remote Control
Remote control
Mounting screws
5/32 x 5/8" (4 x 16 mm)
When Holding the Remote
Control Unit
OI-800-11-EG
Using the Remote Control Unit (continued)
When using the remote control unit, always point the unit's transmitter head
directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Remote control
The remote control unit may be operated either from a non-fixed position or from
a wall-mounted position. To ensure that the air conditioner operates correctly, DO
NOT install the remote control unit in the following places:
• In direct sunlight
• Behind a curtain or other places where it is covered
• More than 26 feet (8 m) away from the air conditioner
• In the path of the air conditioner's airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
• Where there is an obstacle between the remote control unit and air conditioner
(since a check signal is sent from the remote control unit every 5 minutes)
Before mounting the remote control unit, press the ON/OFF operation button at
Unit the mounting location to make sure that the air conditioner operates from that
location. The indoor unit should make a beeping sound to indicate that it has
received the signal.
unit mount
(included)
To take out the remote control unit, pull it forward.
• When using the remote control unit and during air conditioner operation, the
transmitter on the remote control unit should be pointed toward the receiver on
the indoor unit.
• Make sure that there are no objects between the remote control unit and
receiver which could block the signal.
unit
Rear side
Press
Hole
Set in
place
• To prevent loss of the remote control unit,
you can connect the remote control unit to
the mount by passing a string through the
remote control unit and attachment hole.
Receiver
(Transmitter head)
11