Operation And Important Riding Points; Starting A Cold Engine - Yamaha YW50FD Owner's Manual

Read the Owner's Manual carefully
to become familiar with all controls.
If there is a control or function you
do not understand, ask your Yamaha
dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
TIP
This model is equipped with a lean
angle sensor to stop the engine in
case of a turnover. To start the en-
gine after a turnover, be sure to turn
the main switch to "OFF" and then to
"ON". Failing to do so will prevent the
engine from starting even though the
engine will crank when pushing the
start switch.

OPERATION AND IMPORTANT RIDING POINTS

OPERATION AND IMPORTANT RIDING POINTS
EAU15951

Starting a cold engine

NOTICE
See page 5-3 for engine break-in
instructions prior to operating the
EWA10271
vehicle for the fi rst time.
1. Turn the key to "ON" and make
sure that the engine stop switch
is set to "#".
2. Close the throttle completely.
3. Start the engine by pushing the
EAU45310
start switch while applying the
front or rear brake.
If the engine does not start, re-
lease the start switch, wait a few
seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on
any one attempt. If the engine
does not start, try with the throttle
open 1/8 turn.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
EAUT1513
cold!
ECA10250
ECA11042
5-1
EAU15943 EAU15943
1
2
3
4
5
6
7
8
9