LG GSA-H22N Owner's Manual page 10

To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Master drive
(Booting hard disk)
Slave drive
(Super Multi
DVD Rewriter)
(Jumper set to
Slave)
Connecting the Power Connector
Connect the power cable from the computer's power supply to the socket on the drive
unit, fitting the connector firmly into the power in connector. If there is no spare power
cable available in the computer, you will have to purchase a splitter cable of a suitable
type.
Beveled edge up
Connecting the Interface Connector
Connect the IDE cable to the back of the Super Multi DVD Rewriter, making sure the
coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi DVD
Rewriter (Pin 1 is closest to the Power Connector).
Pin1
Master drive
(Booting hard disk)
- OR -
Primary
connector
NOTE : Improper connection may
damage the drive and void the warranty.
Generally, the power connector can only
fit one way.
NOTE : Generally, the IDE connector is
keyed and will only fit one way.
Red-edge
7
Master drive
(Other IDE drive)
Slave drive
(Super Multi
DVD Rewriter)
(Jumper set
to Slave)
Secondary
connector