Millivolt Standing Pilot Lighting Instructions - Empire Comfort Systems DVCP32BP30N-1 Installation Instructions And Owner's Manual

MILLIVOLT STANDING PILOT LIGHTING INSTRUCTIONS (BP3 SERIES)
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop-
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. Before lighting smell all around the appliance area for
gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas
• Do not try to light any appliance.
• Do not touch any electrical switch;
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the
1. Stop! Read the safety information above.
2. Set REMOTE/OFF/ON switch to OFF.
3. Turn off all electric power to the appliance (if applicable).
4. Lower bottom louver assembly.
5. Push in gas control knob slightly and turn clockwise
to "OFF."
GAS CONTROL KNOB SHOWN
IN "OFF" POSITION
Note: Knob cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. Do not force.
6. Wait ten minutes to clear out any gas. Then smell for
gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above. If
you do not smell gas, go to the next step.
7. Find pilot - Follow
metal tube from gas control. The
pilot is behind the burner on the
right side.
8. Turn gas control knob
counterclockwise
"PILOT."
1. Set REMOTE/OFF/ON switch to OFF.
2. Turn off all electric power to the appliance if service is
to be performed (if applicable).
3. Lower bottom louver assembly.
Page 40
erty damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
REMOTE
OFF
ON
THERMOCOUPLE
ELECTRODE
THERMOPILE
PILOT
to
TO TURN OFF GAS TO FIREPLACE
fire department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it; call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
9. Push in control knob all the way and hold in.
Repeatedly push the piezo ignitor button until the
pilot is lit. Continue to hold the control knob in the
for about one minute after the pilot is lit. Release
knob, and it will pop back up. Pilot should remain
lit. If it goes out, repeat steps 5 through 9.
• If the control knob does not pop up when
released, STOP and IMMEDIATELY call a
qualified service technician or gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call
your service technician or gas supplier.
10. Turn gas control knob counterclockwise
"ON."
11. Close bottom louver assembly.
12. Turn on all electric power to the appliance (if
applicable).
13. Set REMOTE/OFF/ON switch to desired setting.
4. Push in gas control knob slightly and turn clock-
wise to "OFF." Do not force.
5. Close bottom louver assembly.
to
32261-5-0414