Removing The Sdram Dimm - Cisco uBR7100 Series Hardware Installation Manual

Chapter 6 Maintenance
Figure 6-6
1

Removing the SDRAM DIMM

To remove the existing DIMM, use the following procedure:
Step 1 Make sure that you are properly grounded.
Step 2 Locate the DIMM and position the chassis so that you are facing the DIMM module you want to remove.
Open the DIMM latches on the DIMM to release the DIMM from the socket. (See
Step 3
DIMM is under tension in the socket; therefore, the DIMM might be released from the socket with some
force.
OL-5916-01
Removing the Cover
1
Cover screws
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
2
C i s
c o
u B R
7 1 0
0
S E
R I E
S
2 Tabs
Upgrading the SDRAM Memory Modules
2
Figure 6-8) The
6-13