Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench
screwdriver
Note: If a part is not in the hardware kit, check to see if it has been preattached.
1. Remove the two screws, the two washers, and
the shipping bracket (not shown) from the rear
of the Frame (1). Discard the screws, washers,
and shipping bracket.
Identify the Rear Stabilizer (7), which does not
have wheels.
Tighten two M10 Hex Nuts (49) onto two
Leveling Feet (16). Next, tighten the Leveling
Feet into the underside of the Rear Stabilizer
(7).
Attach the Rear Stabilizer (7) to the Frame (1)
with two M10 x 25mm Screws (34) and two
M10 Washers (33).
2. Remove the two screws, the two washers, and
the shipping bracket (not shown) from the front
of the Frame (1). Discard the screws, washers,
and shipping bracket.
Orient the Front Stabilizer (8) so that the
Wheels (21) are in the position shown.
Attach the Front Stabilizer (8) to the Frame (1)
with two M10 x 25mm Screws (34) and two
M10 Washers (33).
.
1
34
33
33
1
7
49
16
2
5
and a Phillips
49
16
34
33
1
8
21
21
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PFEVEX74712.0 and is the answer not in the manual?
Questions and answers
Hello,I had to replace thé chain but thé new chain doens t fit into thé pine sprocket of the Front Wheel. Could you help me?
The document does not provide specific details about the chain or the compatibility of the sprocket with a new chain. However, possible reasons why the new chain does not fit into the flywheel sprocket could include differences in chain size, pitch, or width compared to the original chain, incorrect installation, or a mismatch with the sprocket's teeth design. Checking the specifications of both the chain and sprocket and ensuring proper installation may help resolve the issue.
This answer is automatically generated