Assembly - ProForm 280 CSX User Manual

ASSEMBLY

To hire an authorized service technician to assemble the exercise bike, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tools, assembly requires an adjustable wrench
screwdriver
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled.
M8 Locknut M10 Locknut
(10)–6
M8 x 25mm Patch
Screw (45)–6
1. Identify the Front Stabilizer (2).
See the inset drawing. Attach a Wheel (14) to
one end of the Front Stabilizer (2) with an M8
Locknut (10). Make sure that the Wheel is ori-
ented as shown and that it turns freely.
Align the plastic posts on a Wheel Cover (23)
with the plastic posts on the Wheel (14), and
press the Wheel Cover onto the Wheel.
Assemble the other Wheel (not shown) in
the same way.
While a second person lifts the front of the
Frame (1), attach the Front Stabilizer (2) to the
Frame with two M10 x 75mm Carriage Bolts
(30) and two M10 Locknuts (33) as shown.
All manuals and user guides at all-guides.com
.
M8 Curved
(33)–4 Washer (39)–2
M8 x 47mm Patch
Screw (9)–2
M8 Split
Washer (41)–10
M10 x 75mm Carriage Bolt (30)–4
1
2
30
5
and a Phillips
M4 x 16mm M4 x 22mm
Screw (49)–4 Screw (20)–2
1
33
2
14
10
23
Post