Bodypack Transmitter - Electro-Voice R300 User Manual

2.3.1 | Bodypack Transmitter Setup & Operation
1. Insert Batteries
a. Open the battery compartment by pressing in on the latch and sliding the door down.
b. Insert two AA batteries with + and – as indicated.
c. Close the battery door by pushing up.
2. Turn the unit on by pressing and holding the on/off button for 3 seconds, and the LCD display will
light up. If channel has not been set, set channel according to 2.1.
3. Microphone/Guitar Operation.
a. For Lapel and Headworn Microphones the gain switch should be in the LAV position.
b. For Guitar operation the gain switch should be in the INS position.
c. If lapel or headworn microphones are too sensitive and the audio meter on the receiver is
reaching the peak, put the gain switch in INS to lower the gain.
4. Mute Function – press and hold on/off button for 2 seconds until MUTE appears in the LCD
Display, between the Channel and Frequency. The LED above the display will turn red and the sound
is muted. Repeat to turn mute off.
19