Electro-Voice R300 User Manual page 10

DETAILED COMPONENT DESCRIPTIONS
02
4. ClearScan: This feature automates the process of finding a clear channel.
5. During set up make sure the mixer or amplifier input used for the R300 is muted or
turned down to a minimum level.
6. Plug an audio cable (not supplied) into the 3 pin XLR or ¼ inch output of the R300.
Note: The XLR connector is the preferred connection since the output is balanced and will be
more immune to noise for longer runs of cable although either can be used with good results.
Set the balanced output level on the back panel to 12 o'clock (midway in the range) to start and
adjust later if necessary. If the ¼ inch unbalanced output is used, start with adjustment switch in
the -10dB setting.
10
a. To scan for the clearest channel in a group, press and hold
appears in the display, then release the button.
b. When the scan is complete, the display will show the clearest available channel.
c. Use the SYNC button to transfer the new channel as in step 3.
until CLEARSCAN