Electro-Voice R300 User Manual page 11

7. With the transmitter on, speak into the microphone or play the guitar. Turn up the level on the mixer
or amplifier until you are able to hear the desired signal. If no audio is present, repeat setup and
refer to the troubleshooting section.
Note: It may be necessary to adjust the receiver output until the volume level from the wireless
system approximates the level of an equivalent wired microphone/instrument.
8. DISPLAY The main display can be adjusted to display the Channel number or the Frequency
Note: At any time the item not selected for the main display can be shown for 5 seconds by
pushing the SET button once
a. Press and hold the SET button until DISPLY shows in the display.
b. Press SET and FREQUENCY or CHANNEL will flash in the display.
c. Press for FREQUENCY or
d. Display will return to the main screen and the selected item will be displayed.
e. At any time the item not selected for the main display can be shown for 5 seconds by
pushing the SET button once.
for CHANNEL and press SET.
11