Weider 8530 User Manual page 5

2. Insert two 5/16" x 2 1/2" Carriage Bolts (1) up
through the Base (4).
Slide the Front Upright (42) onto the 5/16" x
2 1/2" Carriage Bolts (1) in the Base (4).
Hand-tighten a 5/16" Nylon Locknut (3) onto
each Carriage Bolt. Do not tighten the
Nylon Locknuts yet.
Press a 1" Inner Cap (6) into the Front
Upright (42). Press a 2" Inner Cap (27) into
the Squat Upright (56). Press a 2" Inner Cap
into the VKR Upright (74).
3. Press a 2" Inner Cap (27) into the end of the
Top Frame (55). Press a 1 3/4" Inner Cap
(44) into each end of the crossbar on the Top
Frame. Press two 1" Inner Caps (99) into the
top of the crossbar.
Attach the Top Frame (55) to the Front
Upright (42) with two 5/16" x 2 3/4" Bolts (11),
two 5/16" Flat Washers (8), and two 5/16"
Nylon Locknuts (3).
Attach the Top Frame (55) to the VKR Upright
(74) and the Squat Upright (56) with two 5/16"
x 2 3/4" Bolts (11) and two 5/16" Nylon
Locknuts (3).
Tighten all Locknuts used in steps 1–3.
4. Set two Weight Bumpers (19) on the bracket
on the Base (4) as shown. Set two Weight
Bumpers (19) on the bracket on the Stabiliser
(5).
Stack eight Weights (25) on each set of
Weight Bumpers (19). Be sure that the pin
grooves are all on the same side of each
stack of Weights.
Be careful not to tip either stack of
Weights (25) until step 6 is complete.
2
27
56
74
3
55
27
11
56
74
4
25
19
5—Bracket
4—Bracket
5
27
42
3
4
1
11
3
99
8
44
Crossbar
44
3
42
25
Pin
Grooves
19
6