Connecting An Hdmi Device; Connecting A Dvi Device - Toshiba 32SL800A Owner's Manual

• Acceptable PC signal format :
S-VGA: VESA 800 5 600 @ 56/60/72/75 Hz
XGA: VESA 1024 5 768 @ 60/70/75 Hz
W-XGA: VESA 1280 5 768 @ 60/75 Hz
W-XGA: VESA 1360 5 768 @ 60 Hz
S-XGA: VESA 1280 5 1024 @ 60/75 Hz
However, these signal formats are converted to match
the number of pixels of the LCD panel�
Therefore, the TV may not display small text properly�
• Supported Audio format :
L-PCM, Dolby Digital, sampling rate 32/44�1/48 kHz
• L-PCM : Linear-Pulse Code Modulation
Connecting a HDMI audio system
One HDMI cable (type A connector) is needed�
AV amplifier corresponding to ARC
Back of TV
HDMI's ARC (Audio Return Channel) feature
This feature enables the audio signal of the TV to be sent
to the AV amplifier via the HDMI cable. It will not be
necessary to connect a cable from the audio output of the
TV to the audio input of the AV amplifier to reproduce the
audio received from the tuner of the TV through the AV
amplifier.
Connecting your TV

Connecting an HDMI device

One HDMI cable (type A connector) is needed�
left side of TV
HDMI device
For proper operation, it is recommended that you use a
short HDMI cable�
HDMI cable transfers both video and audio�
Note:
It is possible that some HDMI devices may not
operate properly with this TV.

Connecting a DVI device

One HDMI (type A connector) -to-DVI adapter cable and
analogue audio cables are needed�
DVI device
HDMI (type A connector)-to-DVI adapter cable
For proper operation, the length of an HDMI-to-DVI
adapter cable should not exceed 3m� The recommended
length is 2m�
Back of TV
VIDEO AUDIO
L R
IN
HDMI OUT
OUT
Back of TV
Back of TV
DVI
VIDEO AUDIO
OUT
L R
IN
OUT
43