Vfp20In Log Placement - Empire Comfort Systems VFP20IN30L10N-1 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Warning: Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
pROpER INSTALLATION SEqUENCE:
(Figure 20)
1. Place back (#1) log between rear log support and burner
pan.
2. Place left, front (#2) log onto two (2) left, front pins on burner
pan.
3. Place right, front (#3) log onto two (2) right, front pins on
burner pan.
4. Compare the completed log installation with the appropriate
photo from page 20. Review previous steps to make any
necessary adjustments.
5. Log placement is completed.
Attention: Do not use Figure 20 to order replacement logs. Refer to
Page 34 Parts List and Parts View to order logs for your appropriate
model number.
Apply loose material (glowing embers) per appropriate Installation
Instructions and Owner's Manual. Replacement of loose material
(glowing embers) must be purchased from an authorized distributor.
Application of excess loose material (glowing embers) may
adversely affect performance of the heater.
26497-1-0310

VFp20IN LOG pLACEMENT

WARNING: All previously applied loose material must be
removed prior to reapplication.
Replacement Loose Material (glowing embers)
part Number: 15998
1
2
Log placement
The following WARNING applies when log set is installed onto
an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or propane)
gas. Field conversion is not permitted.
Figure 20
3
Page 19