Rear Callouts - Samson SXD3000 Owner's Manual

Rear Callouts

Exhaust Fan
This variable-speed fan provides cool-
ing to amplifier. Make sure that both
the front and rear panels are kept
free of all obstructions and that cool,
fresh air is accessible at all times.
Input Connectors
Connect incoming signals to these electronical-
ly balanced connectors, using either XLR or ¼"
TRS (Tip/Ring/Sleeve) plugs. The amplifier accepts
input levels of any strength but needs at least +4
dBu to achieve maximum power. The inputs are
wired in parallel, so they can be used to daisy chain
out of each channel to a second power amplifier.
8
Circuit Breaker
This circuit breaker will trip if there is a
fault with the mains voltage or if maximum
output is overloaded for an period. Push it
in to restart the amplifier after a short rest
period.
Speakon® Output Connectors
Use these to connect each channel of the
amplifier to 4- or 8-ohm loudspeakers
Binding Post
Use these to connect each channel of the
amplifier to 4- or 8-ohm loudspeakers. Be
sure to connect the loudspeaker correctly,
with the red (+) terminal normally connected
to the positive input of the speaker and the
black (ground) terminal normally connected to
the negative input of the speaker.
AC Input - Connect
the supplied heavy-
gauge 3-pin "IEC"
power cable here