Zanussi ZFU25200WA User Manual page 11

Warning! This appliance must be earthed.
The manufacturer declines any liability
should these safety measures not be observed.
A
Important! The wires in the mains lead are
coloured in accordance with the following
code:
A Green and Yellow:
C Brown:
D Blue:
As the colours of the wires in the mains lead of
this appliance may not correspond with the col-
oured markings identifying the terminals in your
plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter "E" or by the earth symbol
oured green and yellow.
2. Connect the wire coloured blue to the ter-
minal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp E is secure
over the outer sheath.
www.zanussi.com
B
C
D
E
Earth
Live
Neutral
or col-
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted B. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA ap-
proved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13
amp socket is a serious safety (shock)
hazard. Ensure that it is disposed of safely.
Rear spacers
You can find the two spacers in the bag with
documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two ad-
justable feet at the bottom in front.
2
1
3
11