Table of Contents
Advertisement
Section 6: Customizing Your System
This section describes how to customize your system to suit your needs. Refer to
this section for detailed instructions on programming access codes and setting
time and date.
Programming
The master code (code 40) can be used to program system options, arm and dis-
arm the system and program other access codes. You can program up to 32 addi-
Access Codes
tional access codes (01 through 32). Other access codes, such as system
supervisory and duress codes, are available. Contact your installer for more infor-
mation.
1. Press
2. Enter the two-digit number of the access code you want to program (01-32 for
3. Enter the new code. Access codes must be four digits unless otherwise indi-
4. To exit access code programming, press
5. Record your new codes in "System Information" on page 29 of this booklet.
Access Codes can be custom programmed to limit the options of the user. When
a new access code is programmed, it is programmed with the attributes of the
code that was used to enter [*] [5] programming (attributes 1,3,7).
To change the attributes listed above perform the following:
1. Press
2. Enter the number of the code you want to modify [01 to 32]. The Master code
3. Press the digit corresponding to the attribute you wish to remove or add.
[Master Code]. The red (Armed) light will turn on and the Program-
5
ming icon will be displayed.
access codes, 33 and 34 for duress codes, 40 for master code, 41 and 42 for
supervisor codes). If an access code already exists for the code number you
have selected, it will be replaced by the new code.
cated by your installer. NOTE: Do not use the factory default or obvious codes
such as [1111] or [1234].
(1) Arming, disarming, alarm reset allowed.
(2) Future Use.
(3) Zone Bypassing allowed.
(4) Future Use.
(7) Bell squawk on arming/disarming.
(8) Future use.
[Master Code][9].
5
cannot be modfied.
.
#
19
Advertisement
Table of Contents
