Table of Contents
Advertisement
NOTE: For security reasons, your installer may program the system to pre-
vent you from turning off certain detectors (for example, smoke detectors).
NOTE: If you have 24-hour zones (zones that are continuously on) on your
system, they will stay bypassed until you turn off the bypass using the steps
above (ask your installer for more information).
Checking
Your system continuously checks for a number of possible trouble conditions. If
Trouble
one of these trouble conditions occurs:
Conditions
• The yellow (Trouble) light will be ON until the Trouble is corrected.
• The keypad will beep twice every 10 seconds until it is acknowledged by press-
• A Trouble condition reduces the level of security your system provides. Call your
To view the Troubles that are present, press
To exit the Trouble menu, press
Here is a list of the various Trouble conditions that may occur:
Display:
[1] Service required
16
ing the
key.
#
installing company for service.
Problem and how it should be addressed:
If this number appears, call for service. It represents one or more
of the following Troubles:
Press [1].
1 Low Battery
2
3 General System
Trouble
4 General System
Tamper
5 General System
Supervisory
6 RF Jam
7 NT9204
Low Battery
8 NT9204
AC Fail
.
2
.
#
Low Battery means the battery voltage has
fallen below the
Not Used
Indicates that a peripheral device has a system
fault.
- NT9204 Supply Trouble.
- NT9204 Output Fault.
- RF Jam Verified.
Indicates that a peripheral device has been tam-
pered with.
Indicates that a peripheral device can not com-
municate with the system.
RF Jam indicates interference from an RF (Radio
Frequency) source.
Indicates that the battery voltage has fallen
below the normal operating voltage on the
NT9204 module.
Indicates AC voltage failure on the NT9204
module.
normal operating voltage.
Advertisement
Table of Contents
