Spa Control Operation - Marquis 660 Owner's Manual

1. Temp +/-
2. Light: Press until you see "HOLD" in the LCD display.
3. Temp +/- to engage the hold mode. The panel will scroll "HOLD – ING – FOR
– 0:60" and continue to count down. LCD display will read "DONE"
4. Light: To stop and exit the hold mode at any time. LCD display will read
"DONE"
Filtration cycles (Factory default is 2 hours one time per day)
The electronic controls will allow for additional control for up to two indepen-
dent filtration cycles to be set. This can be useful if your usage patterns vary
from light to heavy and/or you need more or less filtration time to aid in main-
taining clean water. To adjust the filtration times, press the listed buttons in
the following sequence. Button presses must occur within 3-5 seconds of
each other.
1. Temp +/-
2. Light: Press until you see the word "FLTR" with a small "1" in the LCD screen
3. Temp +/- Which will change display to "BEGN". This will be when the cycle
starts during the day or night.
4. Temp +/- To show time. Continue to press to adjust the hour in one hour
intervals
5. Light: To change the display to minutes
6. Temp +/- To change minutes in increments of 15 intervals
7. Light: To set and move to next screen which will be "RUN HRS". This is how
long the cycle will run.
8. Temp +/- To choose the number of hours you want the spa to filter in one
hour intervals
9. Light: To change the display to minutes
10. Temp +/- To choose the number of minutes you want the spa to filter in 15
minute intervals.
11. Light: To set and show end time. This will be displayed in the LCD window
as "F 1 – ENDS – TIME"
12. Light: To move on to filter cycle 2 which will be displayed in the LCD window
as "FLTR" with a small "2".
13. Temp +/- to choose on or off. If on is chosen, repeat steps 3 through 11 to
set filter cycle 2.
14. Light: To exit.
light timer (Factory default is off – recommended)
The LED spa lights can be set to come on and go off at specified times
during the day or night. To set the light timer, press the listed buttons in the
following sequence. Button presses must occur within 3-5 seconds of each
other.
1. Temp +/-
2. Light: Press until you see the word "LITE TIMR" in the LCD display
3. Temp +/- To toggle between on and off
4. Light: To set and change the display to "BEGN" This is when the timer will
start.
29

spa control operation