Protech Systems PMB-531LF User Manual page 66

ONCHIP IDE DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
IDE HDD Block Mode
IDE DMA transfer access
OnChip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
OnChip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
*** On-Chip Serial ATA Setting ***
SATA Mode
On-Chip Serial ATA
X PATA IDE Mode
SATA Port
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode
(most new drives do), select Enabled for automatic detection of the
optimal number of block read/writes per sector the drive can support
2. IDE DMA Transfer Access
To Enable/Disable the IDE DMA transfer access
3. OnChip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel
separately.
4. Primary Master/Slave PIO
PMB-531LF USER
Phoenix – Award CMOS Setup Utility
OnChip IDE Device
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[IDE]
[Auto]
Primary
P1, P3 is Secondary
F7:Optimized Defaults
Item Help
Menu Level ►
If your IDE hard
drive supports
block mode select
Enabled for
automatic
detection of the
optional number
of block
read/writes per
sector the drive
can support.
Page: 4-15