CPU FEATURE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
Delay Prior to Thermal
Thermal Management
X TM2 Bus Ratio
X TM2 Bus VID
C1E Function
Execute Disable Bit
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. Delay Prior to Thermal
The Delay Prior To Thermal BIOS feature controls the activation of
the Thermal Monitor's automatic mode. It allows you to determine
when the Pentium-M's Thermal Monitor should be activated in
automatic mode after the system boots.
2.
Thermal Management
The used Thermal Monitor
3. C1E Function
This is enabled to reduce power during idle operation
4. Execute Disable Bit
To select enable or disable the No-Execution Page Protection
Technology.
PMB-531LF USER
Phoenix – Award CMOS Setup Utility
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
CPU Feature
[16 Min]
[Thermal Monitor 1]
12X
1.404V
[Auto]
[Enabled]
F7:Optimized Defaults
Item Help
Menu Level ►
Page: 4-9