Load Default Setting; Firmware Update - EverFocus ES1625-31 User Manual

4.4 Load Default Setting

Clicking the Load button will make the switch being set to the original configuration.
※ Note: It exclude to change user name, password and IP configuration. If you want to restore
default setting including IP and user name password, then you can press the reset button for
hardware base reset.
More detail information about Load Default Setting - Hardware Base is described as following.
The purpose of this function is to provide a method for the network administrator to restore all
configurations to the default value.
(1) To activate this function, the user should follow the following procedures. Press the "Load
default" button for 3 seconds until you see the LED blinking.
(2) When LED starts blinking, it means the CPU is executing the "load default" procedure. You can
release the button now.
After completing this procedure, all the factory default value will be restored. It includes the IP
address, the user name, the password and all switch configurations.

4.5 Firmware Update

Before the firmware update procedure is executed, you should enter the password twice and then
press Update button. The smart switch will erase the flash memory. There is a self-protection
mechanism in the Boot Loader, so the Boot Loader will keep intact. Even though the power is
turned off or the cable link fails during the firmware update procedure, the Boot loader will
restore the code to firmware update page.
10
ES1625-31