Keyboard power (3-pin KBPWR)
2.
This jumper allows you to enable or disable the keyboard wake-up feature. When you
set this jumper to pins 2–3 (+5VSB), you can wake up the computer by pressing a key
on the keyboard. This feature requires an ATX power supply that can supply at least 1A
on the +5VSB lead, and a corresponding setting in the BIOS.
J1800I-C Keyboard power setting
USB device wake-up (3-pin USBPWB)
3.
Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped,
DRAM refreshed, system running in low power mode) using the connected USB
devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU,
DRAM in slow refresh, power supply in reduced power mode).
J1800I-C USB device wake up
USB device wake-up (3-pin USBPWF)
4.
Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped,
DRAM refreshed, system running in low power mode) using the connected USB
devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU,
DRAM in slow refresh, power supply in reduced power mode).
J1800I-C USB device wake up
1-8
KBPWR
1 2
2 3
+5V
+5VSB
(Default)
USBPWB
2 3
1
2
+5VSB
+5V
(Default)
USBPWF
1
2
2 3
+5VSB
+5V
(Default)
Chapter 1: Product introduction