Telephone Base And Charger Installation; Battery Installation; Battery Charging - VTech CS6519 User Manual

Telephone base and charger installation

Install the telephone base and charger as shown below.
Electrical outlet
(not controlled
by a wall switch)
Telephone base
power adapter
Use only the power adapters and batteries supplied with this product. To
order a replacement, visit our website at www.vtechphones.com or call
 (800) 595-95. In Canada, go to www.vtechcanada.com or call
 (800) 67-7377.

Battery installation

Install the battery as shown below.
. Plug the battery connector
securely into the socket.
3. Slide the battery compartment cover
towards the center of the handset until
it clicks into place.

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below).
• For best performance, keep the handset in the telephone base or charger when
not in use.
• The battery is fully charged after  hours of continuous charging.
Battery indicators
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.
Telephone wall jack
Telephone base
The battery has no or very little
charge. The handset cannot
be used.
The battery has enough charge
to be used for a short time.
The battery is charged.
A DSL filter (not
included) is required
if you have DSL
high-speed Internet
service.
The DSL filter must
be plugged into the
telephone wall jack.
Telephone line cord
. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
4. Place the handset in the telephone
base or charger to charge.
CHARGE
light remains on
when charging.
Battery status
3
Electrical outlet
(not controlled
by a wall switch)
Charger
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
Charger
adapter