Page 1
A limited set of features are described in abbreviated form. Please refer to the online Complete user’s manual for a full set of installation and operation instructions at www.vtechcanada.com. Before using this VTech product, please read Important safety instructions on pages 2 of this user’s manual.
Telephone Handset charger adapter line cord ( for CS6629) ( for CS6629-2) (2 for CS6629-2) (2 for CS6629-3) (3 for CS6629-3) (3 for CS6629-4) (4 for CS6629-4) Battery compartment Battery Telephone base Wall mount cover power adapter bracket ( for CS6629)
Battery installation Install the battery as shown below. Plug the battery connector Place the battery with the label THIS SIDE UP facing up and securely into the socket. the wires inside the battery compartment. Slide the battery compartment cover Place the handset in the telephone towards the center of the handset until base or charger to charge.
Handset overview CID/ /VOLUME • Review the caller ID log when CHARGE light the phone is not in use. • Decrease the listening volume • On when the handset is during a call or message charging. playback. / /VOLUME • Scroll down while in a menu, or in the directory, caller ID log •...
Using the menu Press MENU when the handset is not in use. Press until the screen displays the desired feature menu. Press SELECT. To return to the previous menu, press CANCEL. • To return to idle mode, press and hold CANCEL. •...
Page 6
Mute The mute function allows you to hear the other party but the other party cannot hear you. During a call, press MUTE. The screen displays Muted. Press MUTE again to resume the conversation. The screen displays Microphone on briefly. Call waiting When you subscribe to call waiting service from your telephone service provider, you hear an alert tone if there is an incoming call while you are already on a call.
Page 7
Intercom Use the intercom features for conversations between two handsets. Press INT on your handset when not in use. When you have three or more handsets, use the dialing keys to enter a destination handset number. , INT or any dialing key on the To answer the intercom call, press destination handset.
Speed dial You can copy up to 9 directory entries into the speed dial locations (0 and 2-9) so that you can dial these numbers using fewer keys than usual. To assign a speed dial entry: Press MENU when the handset is not in use. Scroll to Directory, then press SELECT.
Answering system settings Default settings are indicated by asterisks (*). Settings menu Description Options Call screening Screening: On* Set whether you hear the callers while they are leaving messages to you. Screening: Off # of rings 3*; 2; Toll saver; Set the number of times the telephone rings 6;...
Access the answering system remotely Dial your telephone number from any touch-tone telephone. When the system plays the announcement, enter the two-digit remote code. The preset code is 19. Enter one of the following remote commands. Command Description Play all messages. Play only new messages.
• If there is a fax machine connected to the same telephone line, try disconnecting the fax machine. If that solves the problem, consult your fax machine documentation for information on compatibility with answering systems. The answering system does not record messages. •...
Please call 1 (800) 8 BATTERY for information on Ni-MH battery recycling and ® disposal bans/restrictions in your area. VTech’s involvement in this program is part of its commitment to protecting our environment and conserving natural resources. RBRC and 1 (800) 8 BATTERY are registered trademarks of Rechargeable Battery ®...
FCC, ACTA and IC regulations FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation.
VTech will return repaired or replaced Product under this limited warranty. Transportation, delivery or handling charges are prepaid. VTech assumes no risk for damage or loss of the Product in transit. If the Product failure is not covered by this limited warranty, or proof of purchase does not meet the terms of this limited warranty, VTech will notify you and will request that you authorize the cost of repair prior to any further repair activity.
Need help?
Do you have a question about the CS6629-4 and is the answer not in the manual?
Questions and answers