Customer Service - Miele G 7855 Operating Instructions Manual

Water in the wash cabinet is not
heated; the programme sequence
lasts too long
This machine has a resettable heater
limiter which will switch off the heaters if
they over-heat. This could be caused
for example, by large articles covering
the heating elements or if the filters in
the wash cabinet are blocked.
^ Remove the cause of the fault.
^ Take off the service panel (see
"Electrical connection").
^ Press the reset button on the heater
limiter (yellow) located on the left-
hand side of the plastic cover.
If this switch trips again contact the
Miele Service Department.
Correcting minor faults

Customer service

Should you still have any difficulties or if
a fault code "F..." appears in the display
again, please contact your authorised
Service Dealer or the Miele Service
Department. See back cover for
addresses. Please quote the fault code
as well as the model type and number
of your machine.
45