Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Einstein E-Collar ET-302TS
Summary of Contents for Einstein E-Collar ET-302TS
- Page 1 ET-302TS Owner's Manual...
- Page 2 We are confident you will be pleased with the results you will attain with the ET-302TS Two Dog Remote. Please remember you will get better results with the use of lower stimulation combined with consistent training techniques.
- Page 3 Tapping Sensation • Employs Quick Charge Li-Polymer Batteries • Convenient Intensity Dial for Quick Adjustment • Stimulation Levels Adjustable from 0 to 100 • Collar Receiver Light for Night Tracking • Lock and Set Stimulation Feature Einstein Owner's Manual ET-302TS...
-
Page 4: Contact Points
CONTENTS • • Transmitter 2 Collar Receivers • Lanyard • Battery Charger • • Owner’s Manual Test Light ET-302TS Owner's Manual • • Contact Points 3/4" Contact Point Tool Einstein Owner's Manual ET-302TS... -
Page 5: Table Of Contents
Changing the Intensity Level of Stimulation • Lock/Unlock the Stimulation Intensity Level • Indicator Light • Lost Transmitter Mode • Testing Your Einstein • Replacing the Contact Points • Correctly Fitting the Collar • Warranty • Memo • Einstein Owner's Manual ET-302TS... -
Page 6: Safety And General Information
Hospital or Health Care Facility or enter the facility without turning off both units. An FCC license is not needed to operate Einstein E-Collar transmitters. However, any change or modification made to the transmitter, including the supplied antenna, without the expressed written approval of E-Collar Technologies, Inc. -
Page 7: Getting Started
/ Set and Lock Knob Stimulation Button (1D) LCD Display Stimulation Button (2D) Indicator Light (LED Window) Momentary / Continuous Button Light and On/Off Button Mode Button Battery Charging Receptacle On/Off Magnetic Dot and Rubber Cover Einstein Owner's Manual ET-302TS... - Page 8 COLLAR RECEIVER PARTS Collar Strap 5/8" Contact Points On/Off Magnetic Dot Indicator and Tracking Lights (LED Window) THIS D-CLIP IS NOT TO BE USED AS A TIE OUT Battery Charging Receptacle and Rubber Cover Einstein Owner's Manual ET-302TS...
-
Page 9: Charging The Batteries
Battery Charger and Splitter Cable Splitter Cable 120 Volt Charger Charging Cable Wall Outlet Transmitter Battery Charging Collar Receiver Battery Charging Receptacle and Rubber Cover Receptacle and Rubber Cover Einstein Owner's Manual ET-302TS... - Page 10 CHARGING THE BATTERIES The indicator light will turn solid red during charge cycle and • turn green if it is fully charged. Einstein Owner's Manual ET-302TS...
-
Page 11: Turning Your E-Collar On/Off
To turn the Transmitter On or Off : Press the “L” light button for more than 2 seconds. If “L” light button is pressed less than 0.5 seconds, it will turn On/Off Tracking lights of Collar Receiver. Einstein Owner's Manual ET-302TS... -
Page 12: The Lcd Display Features
2D icon stops blinking. In 2D mode, the 1D icon will not be displayed. • In Tapping Sensation mode, the LCD displays "T" as shown in the right picture and you cannot change the stimulation level. Einstein Owner's Manual ET-302TS... -
Page 13: Button Functions
BUTTON FUNCTIONS TRANSMITTER The ET-302TS transmitter is equipped with five control buttons, LCD display, and an adjustable dial. For long range use hold the transmitter up like the Statue of Liberty and never allow the antenna to touch anything as it will decrease the range. Power lines and foliage will also reduce the range. - Page 14 - In Tapping Sensation Mode, Sends a tapping sensation to the Dog 1 collar receiver. - If the current mode is 2D Mode, the mode will be changed to 1D Mode by pressing 1D Stimulation Button. Einstein Owner's Manual ET-302TS...
- Page 15 - If Continuous Stimulation is selected, pressing stimulation buttons (1D or 2D) will send stimulation to the collar receiver for the duration of the button being pressed. After 10 seconds the Over-Stimulation feature will stop the stimulation until the button is released and pressed again. Einstein Owner's Manual ET-302TS...
-
Page 16: Changing The Intensity Level Of Stimulation
“conditioning” stimulation level. You may need to add a few levels later as your dog becomes more conditioned to the stimulation. The “conditioning” stimulation is used when the trainer wants to use the stimulation in continuous mode. Einstein Owner's Manual ET-302TS... - Page 17 Additional pulses may be used to reinforce the command if compliance is not immediate. A treat is recommended after compliance. If a treat is not available, verbal positive reinforcement is acceptable. Einstein Owner's Manual ET-302TS...
- Page 18 YouTube has many videos demonstrating these varying techniques by simply searching “e-collar training” or “remote dog training techniques”. Good Luck with your training! Einstein Owner's Manual ET-302TS...
-
Page 19: Lock/Unlock The Stimulation Intensity Level
LCD display will stop flashing. when you have successfully locked the stimulation level of Dog 2. To unlock the stimulation level simply press the stimulation knob again and it will unlock the stimulation level of the dog selected by the mode button. Einstein Owner's Manual ET-302TS... -
Page 20: Indicator Light
“green” (ready for use) to “amber” (need to charge soon) and then to “red” (charge immediately). When any of the function buttons of the transmitter are pressed, the indicator light on the collar receiver will flicker “red” indicating a control signal has been successfully received. Einstein Owner's Manual ET-302TS... -
Page 21: Lost Transmitter Mode
Lost Transmitter Mode Your Einstein E-Collar transmitter allows the user to turn on a 6 hour timer. After 6 hours the transmitter will began beeping providing the ability to locate the transmitter in tall grass. The timer is activated by first turning the stimulation knob to zero, than pressing the Stimulation Button(Black) and light buttons at the same time. -
Page 22: Testing Your Einstein
Next, change the mode to Tapping Sensation and press the 1D stimulation button to test the tapping Mode sensation feature on the collar receiver for Dog 1 and repeat for Dog 2. Your Einstein E-Collar is ready to use. Einstein Owner's Manual ET-302TS... -
Page 23: Replacing The Contact Points
1. Loosen both contact points by rotating the contact point counter-clockwise using the contact point tool. 2. Install the 3/4” contact points onto the bolt and tighten the contact points by rotating them clockwise with the contact point tool. Einstein Owner's Manual ET-302TS... -
Page 24: Correctly Fitting The Collar
Antibiotic ointment will aid in the healing process. Some dog breeds have very thick fur that requires special contact points, please contact our customer service or visit www.ecollar.com for more information. Einstein Owner's Manual ET-302TS... -
Page 25: Warranty
WARRANTY To Register for the Limited Lifetime Warranty : To register your Einstein product, please log onto our website at www.ecollar.com, click on the warranty registration link and fill out the required information. Please register your product within 30 days of your purchase. -
Page 26: Memo
MEMO Einstein Owner's Manual ET-302TS... -
Page 27: Contact Information
CONTACT INFORMATION E-Collar Technologies, Inc. 2120 Forrest Park Drive Garrett, IN 46738 Toll-Free 1-855-326-5527 Toll-Free Fax 1-855-226-5527 www.ecollar.com sales@ecollar.com Einstein Owner's Manual ET-302TS... - Page 28 Thank you for Supporting American Workers...
Need help?
Do you have a question about the E-Collar ET-302TS and is the answer not in the manual?
Questions and answers