Advertisement
This Motorola document is intended to assist an installer on installation, download, and activation process for
the DSR550 satellite receiver set-top box (STB).
Record STB
Please record the STB unit address (UA) located on the
unit address
label on the rear panel of the STB. It is in the format:
000-XXXXX-XXXXX-XXX.
authorization later in the process.
U/A: 000 - __________ - __________ - ______
Initial
Outdoor electronics are installed and peaked at the Rainbow
Assumptions
1 satellite. Antenna and diplexor are properly wired to
STB.
STB is wired to television via RCA or remod outputs for
installation process only.
HD Component connections should be wired for Final
Configuration.
Plug in STB
The STB will require less than 1 minute to fully power up.
When the power up is completed, a Setup Options screen
will appear.
Verify
Open up the smartcard front panel on the STB to verify that
Smartcard
the smartcard is in place. If no smartcard is present, please
notify Installs, Inc. of missing smartcard.
smartcard will prevent video from being viewed.
Tune
From the Setup Options screen menu, use the remote
Satellite
control unit (RCU) to select option 4. Direct Tune to 255.
Verify DCII
Wait about 1 minute. A green satellite dish icon will appear
Signal
on the STB front panel display. This indicates that you
have acquired the correct Rainbow 1 signal are ready to
receive authorization. If the icon remains red, it indicates a
problem with antenna dish pointing angle, or the wiring
between the antenna electronics and the STB.
If the green satellite dish icon does not appear, you can
This is required for
A missing
2
P
P
1
1
4
4
A
G
E
O
F
A
G
E
O
F
Advertisement
