Storage And Cleaning - Panasonic TY-ER3D4SW Operating Instructions Manual

Storage and Cleaning

Clean using a soft, dry cloth.
Wiping the 3D Eyewear with a soft cloth that is covered in dust
or dirt may scratch the eyewear. Shake off any dust from the
cloth before use.
Do not use benzene, thinner, or wax on the 3D Eyewear, as
doing so may cause the paint to peel off.
Do not dunk the 3D Eyewear in liquid such as water when
cleaning.
Avoid storing the 3D Eyewear in hot or highly humid locations.
During the long period of disuse, full charge the 3D Eyewear
once every 6 months to keep the battery performance.
As the liquid crystal shutters (lens) are fragile and easily
broken, be very careful when cleaning them.
Disposal
A lithium-ion polymer rechargeable battery is built in
to the 3D Eyewear. Please discard according to local
regulations.
When disposing this product, disassemble properly by
following the procedure on the next page, and remove
the internal rechargeable battery.
Do not disassemble this product except when disposing
of it.
Danger
As the rechargeable battery is specifically for this
product, do not use it for any other device.
Do not charge the removed battery.
Do not throw the battery in a fire, or apply heat to it.
Do not pierce the battery with a nail, subject it to an impact,
or dismantle or modify it.
Do not let the wires touch any other metal or each other.
Do not carry or store the battery with a necklace, hair pin,
or the like.
Do not charge, use, or leave the battery in a hot location
such as near a fire or under the hot sun.
Doing so may cause the battery to generate heat, ignite, or
rupture.
10