Storage And Cleaning - Panasonic TY-ER3D4ME Operating Instructions Manual

2. Slide the tab from the OFF position to the ON position.
The 3D Eyewear will power on and start pairing.
Place the 3D Eyewear within 50 cm from the TV while
pairing in progress.
3. The green LED lights on the 3D Eyewear for 3 seconds
when the pairing is successfully completed.
automatically when 3D Eyewear is powered on near the TV in
3D mode.
Pairing Again
When connection with paired TV fails, or when using with
another TV,re-register the 3D Eyewear.
1. Turn on the TV to see.
2. Within 50 cm from the TV, hold the tab on the Mode
position for more than 2 seconds.
The pairing will start.
3. The green LED lights for 3 seconds when the pairing is
successfully completed.
* If the pairing failed, the 3D Eyewear will power off.
* If the pairing failed, power off the TV and perform from step 1.
* Do not connect the charging cable while Pairing Again.
* Release the tab when Pairing Again starts.

Storage and Cleaning

Clean using a soft, dry cloth.
Wiping the 3D Eyewear with a soft cloth that is covered in
dust or dirt may scratch the eyewear. Shake off any dust
from the cloth before use.
Do not use benzene, thinner, or wax on the 3D Eyewear,
as doing so may cause the paint to peel off.
Do not dunk the 3D Eyewear in liquid such as water when
cleaning.
Avoid storing the 3D Eyewear in hot or highly humid
locations.
During the long period of disuse, full charge the
3D Eyewear once every 6 months to keep the battery
performance.
As the liquid crystal shutters (lens) are fragile and easily
broken, be very careful when cleaning them.
(continued overleaf)
9