Download Print this page
   

Advertisement

Operating Instructions
3D Eyewear
TY-ER3D4MA
Model No.
This product cannot be used as sunglasses.
ENGLISH
繁體中文
日本語
TQZJ405

Advertisement

   Summary of Contents for Panasonic TY-ER3D4MA

  • Page 1

    Operating Instructions 3D Eyewear TY-ER3D4MA Model No. This product cannot be used as sunglasses. ENGLISH 繁體中文 日本語 TQZJ405...

  • Page 2: Viewing 3d Images

    Viewing 3D images You can enjoy viewing 3D images with contents or programmes corresponding to the 3D effect by wearing the 3D Eyewear (supplied). “Standard accessories” (p. 6) This TV supports [Frame Sequential] , [Side by Side] and [Top and Bottom] 3D formats.

  • Page 3

    Viewing 3D Content Do not use the 3D Eyewear if you have a history of over-sensitivity to light, heart problems, or have any other existing medical conditions. Please stop using the 3D Eyewear immediately, if you feel tired, are not feeling well or experience any other uncomfortable sensation.

  • Page 4

    Part names and functions 3D Eyewear can be worn over vision correction glasses. Power switch Slide the tab to the “ON” / “OFF” position to switch the power on/off. Each time slide the tab to the “MODE” position to change the mode between 3D and 2D (view a 3D image in 2D).

  • Page 5

    Registration First registration Perform the first registration when the 3D Eyewear is used for the first time. Turn on the TV. Slide the power switch from “OFF” to “ON”. The 3D Eyewear will power on and start registration. Place the 3D Eyewear within 50 cm from the TV while registration in progress. The green LED lights on the 3D Eyewear for 3 seconds when the registration is successfully completed.

  • Page 6

    Replacing the battery When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on. In this case, early battery replacement is recommended. Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local area. Loosen the screw and remove the cover using with a precision Phillips (No.0, plus + ) screwdriver.

  • Page 8

    IC STATEMENT Thi d This device complies with Industry Canada licence-exempt RSS ith I d d li t RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

  • Page 9

    NCC STATEMENT IC ST As the battery is specially for this product, do not use it for any other device. Do not charge the battery. Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it. Do not let the wires touch any other metal or each other.

Comments to this Manuals

Symbols: 0
Latest comments: