2
4
Figure 16
Removal of a stack unit
Removal of a stack unit results in one or more freed cables. In this example, a single cable (red) that was
used to link Unit 2 to Unit 3 has been freed up. The other cable that was going from Unit 1 to Unit 2, is
now used to connect Unit 1 to Unit 3, using the same stack ports that were used initially to once again
complete the ring topology. Move this cable to complete the stack unit removal process.
Validation
2.5.2.2
To validate the stack unit was removed and that the remaining stack members are still intact, go to System
> Stack Management > Stack Summary.
Removing units from the stack configuration
2.5.2.3
Once a unit has been physically removed, it may be desired to remove it from the configuration as well, if
there are no plans on restoring it later. For the above example Unit 2 was removed; however, the Stack
Summary screen continues to show the removed switch in the configuration.
48
Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
7
9
11
13
15
17
19
6
8
10
12
14
16
18
20
SWITCH REMOVED
FROM STACK
1
3
5
7
9
11
13
2
4
6
8
10
12
14
21
23
25
27
29
31
33
35
22
24
26
28
30
32
34
36
1
3
5
7
9
11
13
2
4
6
8
10
12
14
15
17
19
21
LNK
23
ACT
16
18
20
22
24
37
39
41
43
45
LNK
47
ACT
38
40
42
44
46
48
15
17
19
21
LNK
23
ACT
LNK
16
18
20
22
24
LNK
LNK
ACT
ACT
1
2
ACT
10GBASE-T MODULE