Dell Networking N4032 Configuration Manual page 41

Use the freed cables or new cables to connect the two switches together that were previously adjacent to
the switch being removed. Since there are multiple interface and cable types supported for stacking, a
different set of cables may be required to make this connection.
2 4
Figure 14 Removal of a stack unit
Removal of a stack unit results in one or more freed cables. In this example, a single cable (red) that was
used to link Unit 2 to Unit 3 has been freed up. The other cable that was going from Unit 1 to Unit 2, is
now used to connect Unit 1 to Unit 3, using the same stack ports that were used initially to once again
complete the ring topology. Move this cable to complete the stack unit removal process.
Validation
2.5.1.2
To validate the stack unit has been removed and that the remaining stack members are still intact, type the
show switch command.
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- -------
1 Mgmt Sw
2 Unassigned
3 Stack Mbr
41 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
7 9 11 13 15 17 19
6 8 10 12 14 16 18 20
SWITCH REMOVED
FROM STACK
Status
Oper Stby N4064
1 3 5 7 9 11 13
2 4 6 8 10 12 14
21 23 25 27 29 31 33
22 24 26 28 30 32 34
1 3 5 7 9 11 13
2 4 6 8 10 12 14
Preconfig Plugged-in
Model ID Model ID
N4032 N4032
N4032F
N4064
15 17 19 21 LNK 23 ACT
16 18 20 22 24
35 37 39 41 43 45 LNK 47 ACT
36 38 40 42 44 46 48
15 17 19 21 LNK 23 ACT
LNK
16 18 20 22 24
Switch
Status
OK
Not Present
OK
LNK LNK
ACT ACT
1 2
ACT
10GBASE-T MODULE
Code
Version
6.0.1.3
0.0.0.0
6.0.1.3