Testing; Reconnect Battery; Test Power Wiring; View/Set The Clock - Jensen CM715K Installation Manual

®

Testing

Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.

Reconnect Battery

When wiring is complete,
reconnect the battery
negative terminal.

Test Power Wiring

1. Turn ignition switch on. The display should
light. If not, check the electrical connection
at the yellow and red wires.
2. Press PWR button to turn the receiver on.
You will see the radio display. If not, check
electrical connections to the red and
yellow wires.
3. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.
Set the Clock
Press DISP button to temporarily display
clock.
To set the clock:
1
DISP
>2 sec
SCN RPT MTL AMS PGM
2
0
1
2
3
VOL
M
VOL
8
Untitled-3
1. Press and hold DISP
button for more than
two seconds. Colon
will flash.
2. Within 3 seconds,
press on the control
button to change the
minutes and to
change the hours.
VOL
or
H
VOL
8

Test Antenna Connection

1 VOL
or
VOL
1. Press or . The radio should tune to a
nearby station. If not, check antenna
connection.
VOL
2 2. Press the
to increase volume
until you can hear the
VOL
radio playing.

Test Memory Wiring

1. With the radio playing,
CH
1
SCN
hold button 1 for five
seconds. CH 1 will
appear in the display.
5 sec
You just stored the
current station in
2
memory.
2. Turn the key off, then
turn the key on again.
3
VOL
VOL
or
VOL VOL
3. Press
4
SCN
radio will select a
different station.
4. Press button 1 again.
It should return to the
station that was
playing before (step
1). If not, make sure
the yellow wire is
connected properly.
4/10/99, 7:38 PM
CM715K
VOL
VOL
button
VOL
or . The