HP ISCSI SR2122 Getting Started Manual page 13

Configuring the SR2122 iSCSI Storage Router in a SAN
Configuring the SR2122 in a SAN takes on five distinct steps or sections:
■
■
■
■
■
SR2122 Setup
The SR2122 can be configured either as a standalone or clustered device. In Standalone Mode,
as the name implies, the SR2122 does not have failover capabilities to other SR2122s. In
Clustered Mode up to four SR2122s can be used as failover when presenting storage to iSCSI
Initiators.
Note:
standalone router to preserve its configuration.
For further SR2122 configuration details, please read "HP StorageWorks iSCSI storage router
2122 User Guide PN: 304835-002" Chapter 5 – Configuring the Storage Router.
Whether adding SR2122's in Standalone or Cluster modes its important to know the WWPN
of the fibre channel ports as they are needed for configuring both SAN zoning and Selective
Storage Presentation (SSP).
To find the WWPN of a FC ports using the SR2122's CLI enter:
loop:
connection: F Port
Data Rate:
port id:
ALPA:
firmware:
SCSI stats:
WWPN: 28 00 00 02 3d 07 1b c0
.
iSCSI SR2122 Storage Router: Getting Started Guide
Setup/configuration of the SR2122 itself
Adding the SR2122 to a SAN – standalone or clustered
Serving storage to the SR2122 from the storage arrays over Fibre Channel
Serving storage to the iSCSI Initiators from the SR2122 over IP.
Setup/configuration of the iSCSI Initiators
A Standalone SR2122 can be added to a SR2122 Cluster without re-initializing the
SR2122> show interface "fc1" stats
LOOP READY
2 Gb/s
0xb0700
0x0
READY
35 status IOCB
0 type 1 IOCB
5 marker IOCB
0 unhandled IOCB
Configuring the SR2122 iSCSI Storage Router in a SAN
13