Table of Contents
Advertisement
1. Test base for secure installation. See
B
2. Push in
and rotate knobs
restraint at the same time to unlock position.
3. Place child restraint on base in rear-facing position
4. Rotate knobs on both sides of child restraint to lock it
E
into base
. You will see lock symbols in windows on
side of base as shown
5. If you see the red flags up in the child restraint
F
seating area
and you see the unlock symbol
then seat is not secured to base.
6. Check seat is secure by moving front to back and left
to right at the belt path
more than 1 inch ( 2.54 cm). If belt loosens or
lengthens, repeat procedure.
NOTE: Make sure tether is stored. See
. You can not use tether in rear-facing
mode.
NOTE: Bubble in level indicator must be fully
between the two lines
rear-facing use only. See
A
.
C
on both sides of child
H
.
G
. Base should not move
J
. Level indicator is for
34
D
.
I
A
D
F
Hide quick links:
Advertisement
Table of Contents
