Hotpoint RGB744 Use And Care & Installation page 45

CONVERTING TO LP GAS
3
CONVERTING SURFACE BURNERS
1. Remove grates, burner caps and burner heads.
2. Remove the brass orifice
spud inside the chimney of
each burner using a 9/32
or 7 mm nut driver.
3. Install the orifice spuds
according to one of the
following diagrams (see
or ), for LP gas or
B
natural gas, depending on
which you are converting to.
or Converting Back to Natural Gas from LP
Grate
Burner Cap
Drip Pan
(on some models)
Burner Head
Electrode
Chimney
A
Orifice spud
(Sealed Burner models only)
A
Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed
with this Use and Care Guide or on a bracket
next to the pressure regulator. LP orifice spuds
have a 2-digit number and the letter "L" on top.
Each orifice spud will also have 1, 2 or 3 grooves
on the top, and some will have a painted side,
denoting the location on the range where it is to
be installed as shown below.
II
Brass
II
Front of Range
Brass
B
Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds have a 3-digit number
and the letter "N" on the top. Each orifice spud
will also have 1, 2 or 3 grooves on top denoting
the location on the range where it is to be
installed as shown below.
Front of Range
I
White
III
Brown
(continued next page)
45