Hotpoint RGB744 Use And Care & Installation page 13

Hotpoint gas range use and care & installation of models rgb744, rgb745
Hide thumbs Also See for RGB744:
Table of Contents

Advertisement

Power Outage
(on models with press pads)
When power is restored, you will need to reset
the clock.
All other functions that were in operation when the
power went out will have to be programmed again.
Clock and Minute Timer with Dials
To set the clock, push the knob
in and turn the clock hands to
the correct time. Then let the
knob out and continue turning
to OFF.
The minute timer has been combined with the range
clock. Use it to time cooking operations. You'll
recognize it as the pointer that is different in color
from the clock hands.
Automatic Oven Timers with Dials
These timers will
automatically start and
stop your oven for you.
Here's what you do:
1. Make sure both your range clock and the DELAY
START dial show the correct time of day. When
either the DELAY START dial or STOP TIME dial
is pushed in and turned, it will "pop" into place
when the time shown on the range clock is reached.
2. Set the DELAY START dial. Push in and turn the
DELAY START dial to the time you want the oven
to turn itself on. (If you want it to start cooking
immediately, do not set DELAY START time.)
3. Set the STOP TIME dial. Push in and turn the
STOP TIME dial to the time you want the oven to
turn itself off.
(on some models)
12
OFF
0 60
50
9
10
3
20
40
30
6
(on some models)
STOP TIME
DELAY START
12
12
9
3
9
3
6
6
PUSH TO TURN
End of Cycle Tones
The end of cycle tone is a series of three beeps.
Reminder beeps continue until the oven is turned off.
Minutes are marked up to 60 on the center
ring of the clock.
To set the minute timer, turn the knob to the left,
without pushing in, until the pointer reaches the number
of minutes you want to time.
At the end of the set time, a buzzer sounds to tell
you time is up. Turn the knob, without pushing in,
until the pointer reaches OFF and the buzzer stops.
NOTE: There must be at least a half-hour difference
between the DELAY START and STOP TIME dials,
and times can be set only up to 11 hours and 45
minutes in advance.
4. Set the OVEN SET knob to TIME BAKE (or
CLEAN).
5. Set the OVEN TEMP knob to the desired cooking
temperature (or CLEAN).
The oven will turn itself on immediately unless you
have set the DELAY START dial for a later starting
time. It will operate at the temperature you selected
and turn itself off at the Stop Time you selected.
Turn the OVEN TEMP knob to OFF and then take
your food out of the oven.
(on models with press pads)
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rgb745

Table of Contents