Table of Contents
Advertisement
2-3 Performing Scanning
Once you have mounted the object of the machine, you can now perform scanning.
Before you start scanning, make sure the door is closed and turn on the machine.
Basic Scanning
This is the scanning that you perform first after mounting the scan object. The scanning data obtained by executing basic
scanning makes possible a wide variety of operations.
Procedure
1
Start Dr.PICZA3.
From the [Start] menu, choose [All programs (or Programs)], then [Roland
Dr.PICZA3], then [Dr.PICZA3].
Click the [
2
The [Scan] dialog box appears.
Choose the scanning mode that matches the shape of the
3
scan object.
The [Settings for Scanning] dialog box appears.
• Object whose shape is close to a sphere or cylinder
• Object with little unevenness
Choose rotary scanning.
• Other object
Choose plane scanning.
You normally choose plane scanning, which has little restric-
tions as to shape.
Click the [
4
The preview starts.
From this point on, never open the door until scanning ends. Doing
so switches off the power. Scanning cannot be resumed when you
then switch on the power again.
Click
2. Creating 3D Data
32
] button.
] button.
Preview in progress
Click one of these buttons.
The general shape of
The height of the
the object to be
scanning area is
scanned is displayed.
setting automati-
cally at this time.
After preview has finished
Advertisement
Table of Contents
