Initial Installation; Batteries - Remote Control; Connection; Switching On - Loewe Aventos 3781 ZW Operating Instructions Manual

Initial installation

Batteries – remote control
To insert or change the batteries, press the
point marked by an embossed arrow. Push
the cover of the battery compartment down
and remove it. Insert the batteries of the alka-
line manganese type LR 03 (AAA) with the
correct polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to the
national laws. Ask your dealer.

Connection

Mains
Connect the TV set to a 230V/50–60 Hertz
outlet.
Antennae
Remove the rear cover from the Mimo set by
pulling backwards. Clamp the cable in the cable
holder and lead it downwards through the
opening.
Connect your antenna or cable system to the
+
VHF/UHF antenna socket.
If your TV is equipped with a picture-in-picture
tuner (PIP), plug the antenna plug protruding
from above the PIP antenna socket into the
antenna socket for the VHF/UHF tuner. Plug the
+
antenna plug of your antenna or cable system
into the socket of the PIP tuner.
If your TV set is equipped with one or two
satellite tuners, connect the SAT antennae to
the SAT sockets (see figure on page 5).
Refit the cover to the Mimo set.

Switching on

DIG IN
1
RC5/RC6
SAT
SERVICE
IR
2
CTRL
SAT A/D VGA DIG OUT
AUDIO IN
AV1 AV2/RGB AV3
R
AUDIO OUT
VHF/UHF L
SUR
C R
SUBWOOFER
STAND L
SUB
Press the On/Off button so that
it snaps in.
Initial installation
Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the station
search. The TV set searches for, stores and sorts
all the stations which your antenna system
receives. You then see a list of the stored
stations in which you can mark your favorites.
Finally log in your video recorders, decoders,
Loewe audio system and Home Automation
with the connection wizard and connect these
to the TV set according to the illustrated
connection plan.
Select the settings with the
arrows on the ring ...
... confirm the settings with
OK
OK. You then move on to the
next menu ...
... press this button if you want
i
information about the settings.
You can repeat initial installation at any time,
e.g. after moving house. Launch the index in
the main information (i button). Then select the
item "Repeat initial installation". Then start
"Initial installation" with OK.
9