Initial Installation; Batteries - Remote Control; Connection; Switching On - Loewe Aconda 9272 Operating Instructions Manual

Initial installation

Batteries – Remote
control
To insert or change the batteries, press the
point marked by an embossed arrow. Push the
cover of the battery compartment down and
remove it. Insert the batteries of the alkaline
manganese type LR 03 (AAA) with the correct
polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to
the national laws. Ask your
dealer.
BAQ2550H_31308_020_3_GB2

Connection

Mains
Connect the TV set to a 230V/50–60 Hertz
outlet.
Antennae
Connect your antenna or cable system to the
antenna socket of the PIP tuner.
Plug the antenna plug protruding from above
the PIP tuner into the antenna socket of the
VHF/UHF tuner.
+
If your TV set is equipped with a DVB-T module,
connect your antenna or cable systems to the
top socket of the DVB-T module (IN) and con-
nect the bottom socket (OUT) to the antenna
input of the PIP tuner. If equipped with one or
+
two satellite tuners, connect the SAT antennae
to the SAT sockets (see figure on page 5).
RC5/RC6
SAT
SAT A/D
VHF/UHF

Switching on

The On/Off switch on the TV set is located
behind the control panel. Open the flap of the
control panel.
9
DIG IN
1
SERVICE
IR
2
CTRL
VGA DIG OUT
AUDIO IN
AV1 AV2/RGB AV3
R
AUDIO OUT
L
SUR
R
C
SUBWOOFER
STAND L
SUB
Press the On/Off button so that
it is pressed in.
07.05.2004, 10:58 Uhr
Initial installation
Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the station
search. The TV set searches for, stores and sorts
all the stations which your antenna system
receives. You then see a list of the stored
stations in which you can mark your favorites.
Finally log in your video recorders, decoders,
Loewe audio system and Home Automation
with the connection wizard and connect these
to the TV set according to the illustrated
connection plan.
Select the settings with the
arrows on the ring ...
... confirm the settings with
OK
OK. You then move on to the
next menu ...
... press this button if you want
i
information about the settings.
You can repeat initial installation at any time,
e.g. after moving house. Call the index in the
main information (i button). Then select the
item "Repeat initial installation". Then start
"Initial installation" with OK.
9