Sleep Mode - Pride Mobility Jazzy Select Owner's Manual

To unlock the controller:
1. Press the on/off button to turn on the controller. The battery condition meter will flash the "locked" sequence.
2. Move the joystick to the full forward position until it beeps.
3. Move the joystick to the full rearward position until it beeps.
4. Release the joystick. There will be one long beep. The controller system is now unlocked.

Sleep Mode

The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller.
To restore power and continue, push any button on the control panel.
Fault Codes
The battery condition meter will flash fault codes when the controller system detects an abnormal condition is the electrical
system. All of the battery condition meter LEDs will flash a number of times quickly, then pause, then flash again. The
battery condition meter will continue to flash the fault codes until the problem is fixed. The table below identifies the
individual fault codes. If any of these fault codes persist, contact your authorised Pride Dealer.
Fault Code Probable Cause(s)
1 Flash The batteries need charging.
There is a bad connection to the batteries.
2 Flashes There is a bad connection on the left motor.
3 Flashes The left motor has a short to a battery connection.
4 Flashes There is a bad connection on the right motor.
5 Flashes The right motor has a short to a battery connection.
Rippling LEDs The charge inhibit has been activated.
7 Flashes There is a joystick fault.
8 Flashes There is a control system fault.
9 Flashes The park brakes have a bad connection.
10 Flashes An excessive voltage has been applied to
the control system.
36
V I I . O P E R A T I O N
www.pridemobility.com
Possible Solution
Check the battery connections. If the battery
connections are good, then try charging the
batteries.
Check the left motor connections and wiring
harnesses.
Contact your authorised Pride Dealer.
Check the right motor connections and wiring
harnesses.
Contact your authorised Pride Dealer.
Make sure that the battery charger is not
connected to the power base.
Make sure the joystick is in the centre position
and then power off and on again.
Check power module and joystick module
connections and wiring.
Check the left and right motor connections and
wiring.
Check the battery connections.
Jazzy Select