Pride Mobility Jazzy Select Owner's Manual page 28

V . C O M F O R T
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are
preset at the factory for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it
may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if the
following occurs:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorised Pride Dealer before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair's
tendency to tilt forward while decelerating. You can compensate for this by having your authorised
Pride Dealer make a small adjustment to the pre-programmed deceleration setting in the controller
or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tyre must be inflated to 35 psi (2.4 bar) if equipped with pneumatic tyres. The user must
also be seated in the power chair in order to properly adjust the anti-tip wheels.
To adjust the anti-tip wheels:
1. Loosen nut A. See figure 19.
2. Remove bolt B.
3. Raise or lower the anti-tip wheel. Each hole is 1.27 cm
(1/2 in.) apart.
4. Reinstall bolt B.
5. Tighten nut A.
6. Raise or lower the other anti-tip wheel so that it is at the
same height.
28
A D J U S T M E N T S
Figure 19. Anti-Tip Wheel Adjustment
www.pridemobility.com
A
B
Jazzy Select