Setting Printer Alignment - MicroBoards Technology G4 User Manual

7. Click Continue
message appears.

Setting Printer Alignment

The G4 Disc Publisher system has been aligned to 0.1mm precision at the factory. You may need to
fine tune the alignment settings for full surface coverage depending on the media brand and print
surface type. Follow these steps if alignment modification is needed:
1. Launch PrintWrite 2 and configure the Disc Publisher if this has not already been done. (see
page 18).
2. Place inkjet printable media into the input hopper.
3. Click on the Start Button on your Windows computer.
4. Select Settings and then Printers.
5. Right click on the
6. Select Printing Preferences.
7. Select the Alignment Tab.
8. Select the Resolution of
when aligning the printer.
9. Enter the alignment changes into
the Top and Left Side boxes,
using the graphic instructions on
the right side as a guide to moving
the print image on the disc.
10. Click the Apply button.
close the Printing Preferences at
this time.
11. Print a full image disc using
PrintWrite 2 or SureThing. Please
refer to the user manuals for
details on doing so.
12. A disc will be dropped onto the belts and then printed. Once printing is complete, the disc will
be ejected into the output hopper.
13. Examine the printed disc to determine if the alignment is correct. If not, adjust the Top and
Left Side alignment values in the Printing Preferences according to the graphic on the
Alignment tab and repeat steps 11 through 13 with a new disc.
14. Click the OK button on the Printing Preferences once the alignment is complete to close the
window.
 Setting Printer Alignment
12
Anyway if this
Microboards G4 printer icon.
.1mm
Do not
8. Click Finish to complete the driver
installation.