Installation - Hotpoint SD97PC Instructions For Installation And Use Manual

Electric multifunction oven
Table of Contents

Advertisement

The appliance must be installed only by a qualified
person in compliance with the instructions provided.
The manufacturer declines all responsibility for improper
installation which may harm persons and animals and
damage property.
Important: The power supply to the appliance must be
cut off before any adjustments or maintenance work is
done on it.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions prop-
erly, the cabinet containing it must be appropriate. The
figure below gives the dimensions of the cut-out for

installation

(N.B.: Installation in compliance with the
consumption declaration)
cabinet unit.
In order to ensure adequate ventilation, the back panel of
the cabinet unit must be removed. Installing the oven so that
it rests on two strips of wood is preferable. If the oven rests
on a continuous, flat surface, there must be an aperture of at
least45x560mm.
GB
INSTALLATION
under the counter or in a wall
The panels of the adjacent cabinets must be made of heat-
resistant material. In particular, cabinets with a veneer
exterior must be assembled with glues which can with-
stand temperatures of up to 100 °C.
In compliance with current safety standards, contact with
the electrical parts of the oven must not be possible once
it has been installed.
All parts which ensure the safe operation of the appliance
must be removable only with the aid of a tool.
For the correct centring of your appliance, position the 4
tabs on the sides of the oven in correspondence with the
4 holes on the perimeter of the frame. In particular, if the
cabinet side panel:
is 20 mm thick: the removable part of the tab must be
removed (Fig. A);
is 18 mm thick: use the first groove, which is factory-
set (Fig. B);
is 16 mm thick: use the second groove (Fig. C).
Fig. A
To fasten the oven to the cabinet, open the door of the
oven and attach it by inserting the 4 screws (supplied with
the appliance) into the 4 holes located on the perimeter of
the frame.
14
Fig. B
Fig. C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sd97pi

Table of Contents