Remote Control Unit; How To Operate The Heater - RedCore Concept R-4 User Manual

Remote Control unit

How to Operate the Heater

NOTE: The heater may emit a slight harmless smoke when first used. This smoke is a normal condition
caused by initial heating of the infrared element. It will occur only briefly and is not harmful.

Un-package heater: Cut open tape area, fold back flaps and gently turn entire box upside down. Lift
box from Styrofoam packing. Remove Styrofoam, turn upright. We recommend keeping the
package for off-season storage and any transporting needs.

Position: Find a level and unobstructed location to place the unpackaged heater.

Plug in: Plug the power cord directly into an unused grounded 120 volt 15 amp or higher circuit
receptacle.
 Set ON/OFF switch to ON:
position (I). This provides electricity to the unit.
 Set POWER to ON: Press the POWER button on the LCD panel (or remote control) to turn on the
unit. The Actual Temperature will be displayed.
NOTE: The heating function will still not be active. You must press the HEATER on/off button
(see below) to activate the heating function.
NOTE: After pressing the POWER button to ON, the Air Purifier will operate automatically.
9 | P a g e
Press down the switch located on the rear of the heater to the ON