Timer Recording - Magnavox ZV457MG9 A Owner's Manual

You can program the unit to record up to 12 programs
within a month in advance. Daily or weekly program
recordings are also available.
Before recording, make sure to
• Set the clock before setting a timer programming.
• Insert a recordable disc with enough recordable space.
Note
• If you have not set the clock yet:
Entry screen for the clock setting will appear instead
of the timer programming list at step 1. Continue
with the step 5 in "Manual Clock Setting" on page 32
before setting a timer programming.
• Use [s / B] to move the cursor to the left and the
right in the entry screen for the timer programming.
• If a basic recording or one-touch timer recording is in
progress on one component (e.g., VCR) and the timer
recording set for the other component (e.g., DVD) is
about to begin, the unit automatically switches to the
programmed channel for timer recording 2 minutes
before the programmed starting time, and the
recording in progress (for VCR) will be cancelled
UNLESS their recording channels are the same. If their
recording channels are the same, the timer recording
will start without canceling the recording currently in
progress. In this case, the recording of the same
channel will be made on both DVD and VCR.
• You cannot make a program whose recording time
exceeds 12 hours.
• Cancel the timer-standby mode by pressing
[TIMER SET] before operation for either DVD or VCR.
When finished operating, press [TIMER SET] to
resume the timer-standby mode.
• In the timer-standby mode, you can turn on the
power and use the component (VCR or DVD) which is
not currently timer-programmed.

TIMER RECORDING

Guide to Timer Programming Display
3
Timer Programming
JAN/ 2/09 12:00 AM 69.1 SP
SP (1:00)
Date Start
JAN/02 12:00AM 1:00AM
New Program
4
1 Title of a timer program (Contains date, time, channel,
recording mode of the program)
2 Current date and time
3 Recording mode, and length of the recording
4 Timer program list
5 Total number of pages and current page (2 pages
maximum)
6 Recording media (" " (DVD) or "
1
Press [TIMER].
Use [K / L] to select "New Program",
2
then press [OK].
Timer Programming
Date Start
New Program
• If there are 6 or more programs, use
[H / G] to change pages.
Use [K / L] to enter the date, then
3
press [B].
Date Start
JAN/02 - - : - -
CH REC To
DTV69. 1 DVD
JAN/01
Daily
MON-SAT
MON-FRI
SAT
FRI
SUN
JAN/31
1 2
THU JAN/01 11:00AM
End CH
6
DTV69. 1
1/1
5
" (VCR))
THU JAN/01 11:00AM
End CH
End
- - : - -
Mode
SP
SP 2h00m
When pressing [L] at
the current date, the
date will change as
follows.
e.g.) January 1st
EN EN 43 43