Table of Contents
Advertisement
CHAPTER 2 – USING THE CONTROLS AND MODES
2.1 SETTING THE CLOCK (for key references see page 7)
•
When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the clock, proceed as described below:
•
If you wish to change the hour on the dial once it has been set, press the
ceeding to set the new time as described above.
•
It is possible to display the current time even after starting the mode set, by pressing the
(the time is displayed for 2 seconds).
14
1
Press the
key (6).
(The hours flash on display 1)
2
Set the desired time by turning
the
knob (14).
(The hours flash on display 1)
3
Press the
key (6) again.
(The minutes flash on display 1)
4
Set the desired minutes by
turning the
knob (14)
(The minutes flash on display 1)
5
Press the
key (6) again.
(The display shows the time set)
key (6) before pro-
key (6)
Advertisement
Table of Contents
